MET 330 Unit 5 Discussion

For your analysis of the system, you were given the restriction of using an axial flow impeller pump. Your project task is to specify an axial flow impeller pump and determine operating conditions based on the information provided to you in the Project and the information below. The pump will fulfill the design requirements for the system shown in the figures below. It is a combination series/parallel system that operates as follows:

Brine at 160°F (SG=1.04, m=10^-3 Pa*s) is drawn at a minimum rate of 250 gal/min from a tank

into the 4-in suction line of the pump. The suction line has a total length of 10 ft.

The 3-in discharge line elevates the water 15 ft to the level of a large heat exchanger. The

discharge line has a total length of 40 ft.

The flow splits into two branches with the primary 3-in line feeding a large heat exchanger that

has a K-factor of 12 based on the velocity head in the pipe. These branches were examined in

Part 1 of the project.

Determine the system resistance operating curve for the system.

All pipes are Schedule 40 steel.

250 words in word document with full analysis, in APA 6^th edition reference format.